![]() ![]() sometimes that hard build up ofdeposits will stick in the small passages and wont come out with compressed air. Runs out of power at high RPM1, a week coil will fail under heavy load, but would continue to fire if the mixture is richer (choke out)2, he should clean it again, and run a wire or small drill bit through ALL the passages and jets. I blew out the fuel intake line with air and it started. Looking at your carburetor commentary the common problem with gas running out of it, is often dirt from the gas. Message from customer: It,s a John Deere 1020 tractor. The viton tip can easily be damaged.Ĭlean the viton tip with mineral spirits by wiping off with a paper towel until you don’t get any black on the towel. Make sure he float isn’t hanging up somehow and not closing the needle.īe sure not to put pressure on the needle when adjusting the float. Also check to make sure the old gasket wasn’t left. Some have gravity fed carburetors, but they usually have a tendency to run lean, not rich.įuel could be leaking around the seat. ![]() Seems it is flooding (getting too much fuel).Ĭheck the pressure of the fuel pump assuming you have one. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |